TALBOT 32mm X 1 Inch Push Fit Lead Adapter- E9346

Description

TALBOT Push Fit 32mm x 1″ PE & Lead is also available in 5 sizes in this section

• 20mm x 3/4″ 9lb Talbot Push Fit PE & Lead – Talbot E9343
• 25mm x 1″ 16lb Talbot Push Fit PE & Lead – Talbot E9345
• 25mm x 1/2″ 7lb Talbot Push Fit PE & Lead – Talbot E9238
• 25mm x 3/4″ 9lb Talbot Push Fit PE & Lead – Talbot E9344
• 32mm x 1″ 16lb Talbot Push Fit PE & Lead – Talbot E9346

• 20mm x 1/2″ 7lb Talbot Push Fit PE & Lead – Talbot E9342 (no longer available – discontinued)

 

The Talbot Pushfit joint is a tried and tested method of jointing low, medium and high density polyethylene water pipe, from 16mm to 180mm and their imperial equivalents. The fitting is quick and easy with no nuts to leave undone – simply push the pipe into the joint. The joint’s grip and seal on the pipe increases with water pressure and tensile load which means that the pipe will burst or neck before the joint fails.

Using a common body and only two sets of interchangable components, Talbot Pushfit will connect to metric PE pipes and their imperial equivalents

IMPORTANT NOTE, MOST PLUMBING PRODUCTS ARE STATED AS BSP IMPERIAL THREAD MEASUREMENT WHICH MEANS THAT ACTUAL DIAMETER OF THE THREAD SIZE IS APPROXIMATELY 1/4 INCH LARGER THAN THAT STATED IN BSP TERMS. FOR EXAMPLE THIS 1 INCH BSP THREAD ACTUALLY MEASURES APPROXIMATELY 1 1/4 INCH IN DIAMETER

Additional information

Weight	0.2 kg
Brand
Manufacturer Number
UPCEAN Number
Product Type	Adapter, MDPE Adapter
Pipe Size
Thread Size