E3043 – TALBOT Reducing Tee With Female Thread (25mm X 25mm X 1/2″)

Description

TALBOT reducing tees for connecting MDPE to two branches and having a female thread on the third branch, are available in 4 variations all available in this section. For other sizes you can enter the product code shown below into the search above or use the site navigation 20mm x 20mm x 1/2″ Talbot Female Iron Tees Tees – Talbot Product Code E3035 25mm x 25mm x 1/2″ Talbot Female Iron Tees Tees – Talbot Product Code E3043 25mm x 25mm x 3/4″ Talbot Female Iron Tees Tees – Talbot Product Code E3044 32mm x 32mm x 1″ Talbot Female Iron Tees Tees – Talbot Product Code E3045 The Talbot Pushfit joint is a tried and tested method of jointing low, medium and high density polyethylene water pipe, from 16mm to 180mm and their imperial equivalents. The fitting is quick and easy with no nuts to leave undone – simply push the pipe into the joint. The joint’s grip and seal on the pipe increases with water pressure and tensile load which means that the pipe will burst or neck before the joint fails. Using a common body and only two sets of interchangable components, Talbot Pushfit will connect to metric PE pipes and their imperial equivalents – IMPORTANT NOTE, MOST PLUMBING PRODUCTS ARE STATED AS BSP IMPERIAL THREAD MEASUREMENT WHICH MEANS THAT ACTUAL DIAMETER OF THE THREAD SIZE IS APPROXIMATELY 1/4 INCH LARGER THAN THAT STATED IN BSP TERMS. FOR EXAMPLE THIS 1/2 INCH BSP THREAD ACTUALLY MEASURES APPROXIMATELY 3/4 INCH IN DIAMETER

Additional information